Media

Automate Your Bottom Line • Call (847) 304-4413

Media

Silicone Cartridge Dispense

Dispensing from caulk cartridge at slow speeds. We subsequently retrofitted a pail pump when volume justified it. Note the accurate following at very slow speeds – not as easy as it sounds!

Rotary Axis about Y

Custom rotary axis about Y, vs. standard about Z. The application required that silicone be dispensed on a pipe-shaped part, in addition to the primary use of  XYZ dispensing in a large envelope.

Large Dot Dispensing Array

Dot dispensing with standard arraying feature of the system. There are a total of 12 programmed points to do an array 8 dots each at 600 positions, for a total of 4800 dots. DASA’s arraying feature is very accurate over large arrays (this one is 460 x 660mm), because it is NOT step and repeat. Instead, it segments the total array length in each direction to determine array points.

Laser Calibrator

Laser tool calibrator for dispense tips, router bits, variety of other tools. The robot jogs the tool to the beam in appropriate increments for tool size. X and Y are calibrated, then Z calibration finds the end of the tool. The resulting offset is applied to program coordinates for high repeatability with variations in tooling.  A handy calibrator for disposable tools or just to confirm tooling is OK.

Arrayed Pairs of Short Beads

Short beads with standard arraying feature of the system. Each array point is 2 beads. DASA’s arraying feature is very accurate over large arrays  because it is NOT step and repeat. Instead, it segments the total array length in each direction to determine array points.

Heated Potting Fixture, On-Board

Dispensing epoxy into Heated Fixture, custom to the parts and application. The heat helps potting settle quickly, reducing wait time for topping off the parts. It also prevents trapped air or cavities in the potting.

Bead-on-Bead Dispensing

Unique dispensing from  6” height for Bead-On-Bead Adhesives. These materials are mixed by impact with the part, so they are dropped about 6” to provide this energy. A challenge for getting the bead straight, with this distance in play.

Filter Endcap Dispensing

Dry run of dispensing potting on small end-caps. Convenient and effective for applications where medium volume limits automation expense. We can integrate a wide variety of dispense equipment.

Automatic Feed Screwdriver on Desktop Robot

Desktop Robot, Safety enclosure, Bowl/Blow-fed screwdriver system integrated for PCB and housing cover screwdriving. An inexpensive sensor detects the part status and calls the context-correct program (note the short pause in the work envelope before starting work). Operators need only load the part and push Start